Stabilizer index · TX
TX AP
Plate mount
About
The same doubleshot AP stem in a plate mount housing, cut for 1.5 mm plates and following Cherry sizing. Plate mount is the compromise fitting: nothing to screw and no drilled PCB required, at the cost of play in the clips that cannot be lubricated out, so this is the one to buy when the board gives you no choice rather than when it does. Three of the six shops carry it and all three list four 2u wires plus a 6.25u and a 7u, which covers a 60 percent or a TKL either way. Housing and wire materials are not stated by any of them.
Where to buy
Prices and stock change often. Every link is re-checked on the date shown above.